Signamax Model -065-7700 - Manual (Page 135)

Hardened Managed PoE Ethernet Switch
User’s Manual 134
poe system-power-budget LEVEL
LEVEL <1-800> specifies the power budget (Watts) to be set to Switch.
4.
Example:
The following example sets new power budget 246 Watts to Switch:
switch_a(config)#poe system-power-budget 246
switch_a(config)#
Enable Mode:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use poe enable command to enable this port to discover Powered Device
(PD) connected to this port.
Use the no poe enable to disable this function.
3.
Command Syntax:
(no) poe enable
4.
Example:
The following example shows the use of poe enable to the interface fe1 (port
1):
switch_a(config)#interface fe1
switch_a(config-if)#poe enable
switch_a(config-if)#
Fixed Power Limit (W):
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use this command to specify the fixed power limit for this port to provide
power to PD.