Signamax Model -065-7700 - Manual (Page 152)

Hardened Managed PoE Ethernet Switch
User’s Manual 151
2.
Usage:
Use this command to set the cost of a path associated with an interface. Use
the no parameter with this command to restore the default cost value of the
path. A lower path-cost indicates a greater likelihood of the specific interface
becoming a root.
3.
Command Syntax:
bridge GROUP instance INSTANCE_ID path-cost PATH_COST
GROUP <1-1> Specify the bridge-group ID.
INSTANCE_ID <1-15> Specify the instance ID.
PATH_COST <1-200000000> Specify the cost of path in the range of
<1-200000000>.
4.
Example:
The following example sets the path cost (1000) for Multiple Spanning Tree
instance (3) to a port (fe1) in bridge GROUP (1):
switch_a(config)#interface fe1
switch_a(config-if)#bridge-group 1 instance 3 path-cost 1000
switch_a(config-if)#
Recover-Ring(tm) Capability
Ring state:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to enable Ring state. Use the no parameter with this
command to disable Ring state.
3.
Command Syntax:
bridge GROUP protocol ring
no bridge GROUP ring enable BRIDGE-FORWARD
GROUP <1-1> Specify the bridge-group ID.
BRIDGE-FORWARD Puts all ports of the specified bridge into the
forwarding state.
4.
Example:
The following example enables Ring state in bridge GROUP (1):
switch_a(config)#bridge 1 protocol ring
switch_a(config)#