Signamax Model -065-7700 - Manual (Page 180)

Hardened Managed PoE Ethernet Switch
User’s Manual 179
switch_a(config)#
2.
Usage:
Use ip igmp snooping querier command to enable IGMP querier operation
on a subnet (VLAN) when no multicast routing protocol is configured in the
subnet (VLAN). When enabled, the IGMP Snooping querier sends out
periodic IGMP queries for all interfaces on that VLAN.
Use the no ip igmp snooping querier command to disable IGMP querier
configuration.
3.
Command Syntax:
(no) ip igmp snooping querier
4.
Example:
The following example enables IGMP snooping querier:
switch_a(config)# ip igmp snooping querier
switch_a(config)#
IGMP mode:
Passive:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use ip igmp snooping command to enable IGMP Snooping. This command
is given in the Global Config mode. IGMP Snooping is enabled at the switch
level.
Use the no ip igmp snooping command to globally disable IGMP Snooping.
3.
Command Syntax:
(no) ip igmp snooping enable
4.
Example:
The following example enables IGMP snooping on the switch:
switch_a(config)# ip igmp snooping enable
switch_a(config)#
IGMP version:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vlan1.1 means vlan 1.