Installation, Selecting a site for the switch, Wiring diagram – Signamax Model -065-7700 User Manual
Page 21
Hardened Managed PoE Ethernet Switch
User’s Manual 20
Installation
This chapter gives step-by-step instructions about how to
install the switch:
Selecting a Site for the Switch
As with any electric device, you should place the switch
where it will not be subjected to extreme temperatures,
humidity, or electromagnetic interference. Specifically, the
site you select should meet the following requirements:
-The ambient temperature should be between -40℉ to 167℉ (-40℃ to 75
℃).
-The relative humidity should be less than 95 percent, non-condensing.
-Surrounding electrical devices should not exceed the electromagnetic field
(RFC) standards.
-Make sure that the switch receives adequate ventilation. Do not block the
ventilation holes on each side of the switch.
Wiring Diagram
Field Wiring Terminal Markings: Use Copper Conductors Only,
60/75℃, wire range 12-24 AWG, torque value 7 lb-in.