Signamax Model -065-7700 - Manual (Page 92)

Hardened Managed PoE Ethernet Switch
User’s Manual 91
Add Radius:
1.
Add Radius: Click “Add Radius” button. The “Radius Server Setting”
window appears.
2. Radius Server IP: Click in the “Radius Server IP” textbox and specify the
IP address of the remote radius server host.
3. Radius Server Port: Click in the “Radius Server Port” textbox and
specify the UDP destination port for authentication requests. The host is
not used for authentication if set to 0.
4. Secret Key: Click in the “Secret Key” textbox and specify the
authentication and encryption key for all radius communications
between the Switch and radius server. This key must match the
encryption used on the radius daemon. All leading spaces are ignored,
but spaces within and at the end of the key are used. If spaces are used
in the key, do not enclose the key in quotaion marks unless the
quotation marks themselves are part of the key.
5. Timeout <1-1000>: Click in the “Timeout” textbox and specify the time
interval (in seconds) that the Switch waits for the radius server to reply
before retransmitting. Enter a value in the range 1 to 1000.
6. Retransmit <1-100>: Click in the “Retransmit” textbox and specify the
number of times a radius request is resent to a server if that server is not
responding or responding slowly. Enter a value in the range 1 to 100.
7. Submit: Click “Submit” button when you finished Radius Server Setting.