Adtec digital mediaHUB-HD Pro (version 03.07.19) Manual - Manual (Page 12)

Front Panel Illustration
The mediaHUB-HD should be installed into a one-rack unit 19” rack slot. Power should be applied to the unit and configured
with a valid IP address via the front panel. Once the IP is configured, you can use Telnet or a web browser to configure and
control the unit.
Encoder LED Status
Encode
Off: not encoding
Green flash: pre-roll
Green: encoding
Yellow: transition from encode to idle
Red: no video
Video
Off: no video/not enabled (audio only )
Green: video present
Yellow: wrong format
Red: no video present
Resolution
Green: 1080i HD
Yellow: 720p HD
Off: Standard Def.
Audio 1 & 2
Off: no audio present
Green: audio present
Control
Off: mode not enabled
Green: Control Detected/Remote Mode
Yellow: Control Detected/Local Mode
Red: Control not responding.
Alarm
Off: no Encoder alarm
Red: Encoder alarm
Decoder LED Status
Decode
Off: not decoding
Green flash: pre-roll
Green: decoding
Video
Off: no video (audio only)
Green: decoding video
Yellow: decode errors
Red: decoder fail
Resolution Green: 1080i HD, Yellow: 720p HD, Off: Standard Def.
Audio 1 & 2
www.adtecdigital.com