Adtec digital mediaHUB-HD Pro (version 03.07.19) Manual - Manual (Page 87)

Contribution with Dolby E using the Adtec mediaHUB HD Pro
This procedure allows the introduction of Dolby E audio into the mediaHUB HD Pro.
Dolby-E DP571 Audio Encoder Settings:
Output Data: 20-bit precision •
Program Configuration: 4 x 2 •
Set AES input (1 or 2) to receive Dolby E:
Step Action
1 On the mediaHub front panel, select the Encoder menu
2 Select either Audio 1 or Audio 2
3 Select type as AES
4 Set "Dolby Audio Input" to Compressed
5 Set Layer to "0" (zero)
6 Ignore "Bitrate"- this will be auto-detected from the Dolby input
7
Assuming Audio 1 is being used for Dolby E, set Audio 2 to have AES input type, Dolby OFF, and a Layer setting of
"2"
Adjust audio lip-synch to plus-or-minus 800 milliseconds
Process Flow:
www.adtecdigital.com