Adtec digital mediaHUB-HD Pro (version 03.07.19) Manual - Manual (Page 79)

Media Encoding Parameters for Adtec Decoders
Using Adtec Decoders
If you are using this device to encode content to be used with Adtec Decoders (Soloist, edje-4111, displayMate and signEdje)
we recommend the following encoding parameters:
When creating content for the Soloist and edje 4111HD, you need so ensure that your encoding parameters match
the decoder for best results. •
MPEG 2 Encoding
When creating MPEG2 files, it is recommended to use the following parameters:
Multiplex Type: MPEG2 Transport Stream
Transport Steam composition:
1. The file should start with a transport sync byte (0x47) and should maintain packet alignment throughout the entire duration.
2. There should be a minimal amount of fill packets at the start of the file.
3. The first non-fill packet should be the PAT packet.
4. The next non-fill packet should be the PMT packet(s).
5. The next non-fill packet should be the first video stream packet.
The first video stream packet should contain the following:
Adaptation indicator marking the presence of a PCR.
The adaptation flag field should have the discontinuity indicator set. ◊
♦
Valid PES header with PTS and DTS. ♦
Valid video sequence header and GOP header. ♦
•
6. Use the following recommended PID values:
PMT: 0x1e0 (480dec) •
PCR: 0x1e1 (481dec, must reference video PID) •
Video: 0x1e1 (481dec) •
Audio1: 0x1e2 (482dec) •
Audio2: 0x1e3 (483dec) •
Audio: 192Mbps AC-3 or MPEG Layer 2
HD Content:
Resolution: up to 1920x1080 (1080i60 or 1080i50) •
Bit Rate: 25Mbps constant bit rate (CBR). •
SD Content:
Resolution: 720x480 NTSC or 720x576 PAL •
Bit Rate: 8Mbps constant bit rate (CBR). •
Note: Content should be padded with black frames front and back for improved visual transitions between clips.
MPEG 4.10/AVC/H.264 Encoding
H.264, MPEG-4 Part 10, or AVC, for Advanced Video Coding, is a digital video codec standard which is noted for achieving
very high data compression. The ITU-T H.264 standard and the ISO/IEC MPEG-4 Part 10 standard (formally, ISO/IEC
14496-10) are technically identical.
When creating AVC files, it is recommended to use the following parameters:
www.adtecdigital.com