Axel Remote Management V2 - Manual (Page 59)

Axel Remote Management
53
This chapter describes the auto-configuration function.
The auto-configuration function allows a terminal to automatically obtain a new
firmware file and/or a pre-defined configuration. This is achieved without any
human intervention at the terminal.
Note: the auto-configuration function is available only on M65C, M75, M75E,
M75B and M75C terminals
Auto-configuration requests are sent by the terminal:
- Automatically at the very first power-on,
- At each boot time (if this had been enabled in the terminal set-up).
It is necessary to configure AxRM beforehand with information of which
firmware and configuration files are to be sent to which terminals.