Axel Remote Management V2 - Manual (Page 75)

Axel Remote Management
69
To launch this command select menu [Advanced]-[Set an IP Address to a
device]:
Step 1 - enter new IP address IP to assign to the terminal
Step 2 - identify the terminal by either serial number of Ethernet MAC address
Step 3 - run command by pressing [Set this IP Address to this Device]
About "use the native ARP support": for Windows 95 and 95 or if multiple
network interfaces are installed, it's recommended to uncheck this option (in
this case a DOS command is used to address the ARP table).