Becker TRAFFIC ASSIST HIGHSPEED 7934 - Manual (Page 24)

23
General operations
Fitting the unit bracket
The unit bracket can be secured directly
to the inside of the windscreen or to the
dashboard.
On the windscreen
If the dashboard is too far away from
the driver, the unit bracket can be
fitted irectly to the windscreen using the
suction mechanism.
X If the adapter plate (4) is already secu-
red at the foot (5), remove this. Pull
the lever (3) upwards and remove the
adapter plate (4) downwards for this
purpose.
X Find a suitable position.
X Press the base (5) with its suction sur-
face against the windshield.
X Rotate the unit bracket so that the sup-
port plate is roughly in the direction of
viewing required.
X Press the lever (3) downwards.
The bracket will have stuck firmly to the
windscreen. It can now be set precisely.
To remove, actuate the lever (3) again.
On the dashboard
An adapter plate is provided for moun-
ting on the dashboard. This is stuck on to
the dashboard. The mounting face may
only be slightly curved.
X Find a suitable position.
X Remove the protective film from the
lower contact surface of the adapter
plate (4). Press the adapter plate (4)
onto the instrument panel.
X Take the unit holder, pull the lever (3)
upwards and position the base (5) with
its suction surface into the upper con-
tact surface of the adapter (4).
X Turn the unit holder such that the car-
rier plate is positioned roughly in the
desired viewing direction.
X Press the lever (3) downwards.
The bracket will have stuck firmly to the
adapter. It can now be set precisely.
To remove, actuate the lever (3) again.
Note:
Fasten the unit holder such that your
field of vision is not impaired when the
Traffic Assist Highspeed is installed
and ensure that the unit is outside the
deployment area of the airbag.
Ensure that the electrical connection
cable does not hamper you from acces-
sing the vehicle's controls.
Also ensure that there is enough space
to easily slide the Traffic Assist High-
speed back out of the bracket.
Clean the mounting area on the wind-
screen or dashboard so that it is clean
and free of grease. Do not use smearing,
soapy cleaning agents, otherwise this
may affect how it sticks to the dash-
board. Note:
If the adapter plate is removed, you may
find residue from the glue on your dash-
board.