Becker TRAFFIC ASSIST HIGHSPEED 7934 - Manual (Page 58)

57
Navigational mode
If dynamic route guidance is active, a
continuous check is made for the
presence of relevant announcements for
the selected route (however, traffic
problems still appear on the map even
when route guidance is not active).
If these continuous checks determine
that a traffic announcement is relevant to
route guidance, the unit will
automatically recalculate a new route to
the destination (See “The TMC button*”
on page 54.).
Displaying TMC messages on
the map*
Current TMC messages are displayed on
the map in graphic form. Sections of the
route where there are problems with
traffic are highlighted green. A black
arrow also indicates the direction of the
traffic jam.
In addition to the coloured mark, a
warning sign is displayed on the stretch
of road affected.
Using TMC*
Once you have connected the TMC
antenna, your Traffic Assist Highspeed
will receive current traffic
announcements and dynamic route
calculation will be enabled (traffic jam
diversion). You can also view traffic
announcements directly.
To preset the TMC, See "The TMC
button*" on page 54.
X Press the map on the map display.
X Press the TMC button.
All current traffic announcements are
displayed.
Note:
As the traffic announcements are trans-
mitted by radio stations, we cannot as-
sume responsibility for the complete-
ness or accuracy of the announcements.
Austria: The location and event code
was made available by ASFINAG and
BMVIT.
6071
6071 6071
*Applies only to the Traffic Assist Highspeed II