Beisler 2211-5 - Manual (Page 21)

- B 21 -
Short Seam Automat 2211-5 Working Instructions Beisler Automated Sewing Equipment
B.2
Functions of the machine
B.2.10 Machine cycle left side pocket
The machine cycle "Clipping left side pocket and sewing
it to the left trousers component" is performed as follows:
•
The left side pocket is lined up manually at the pick-
up plate.
• The cloth ledge is clipped, crimped over by the folder
and picked up.
• The left trousers component is positioned manually on
the working plate.
After the cutter has clipped the trousers component,
the folder transports the side pocket to the left trousers
component and puts it down.
• The trousers component with the side pocket is auto-
matically transported by the transport system to the se-
wing head where it is tucked.
• The finished sewing piece is then blown off the workta-
ble with compressed air.
• The assistance transport is activated.
B.2.11 Lining up left pocket at trousers component
Ideally, the side pocket and the left trousers component
are premarked by a gusset. If a gusset is not available,
the line-up position is marked with tape or with a felt pen
at the working plate or at the pick-up plate.
Side pocket line-up position, Fig.11:
The slash selvage clamp is closed during the line-up
process.
The cloth ledge 1 of the side pocket 3 is lined up
at the stop rail 6 of the pick-up plate 4. The exact
position to the cutter 5 is marked by the gusset in
the cloth ledge.
Crimping over and picking up the side pocket, Fig. 12:
The folder 1 moves right to the pick-up plate. The cloth
ledge of the side pocket 3 is clipped by the cutter 2
and crimped over and picked up by the folder clamp 6.
The cutter 5 of the working plate opens, the
cutter 8 is passive and remains concealed in the
working plate.
Left trousers component line-up position, Fig.12:
The left trousers component 4 is aligned with the gus-
set at the cutter 5 and parallel to the pick-up plate and
the folder at the red marking 7 of the guide laser.
Fig. 11/12
Fig. 11
Fig. 12