Beisler 2211-5 - Manual (Page 89)

- D 89 -
Short Seam Automat 2211-5 Working Instructions Beisler Automated Sewing Equipment
D.3
Programming
D.3.8 List of special parameters
Special parameters are values that refer to only one
specific sewing program. Changes of these values affect
only the currently selected sewing program for which the
setting is made.
Special parameters are edited in four different levels (level
2 to level 5).
Special parameters can be functions that may be enab-
led or disabled or parameter values that are set in lists. „ „ „ „ „ Request / exit special parameter menu:
Change from service menu start level to level 1:

• Press  key.
'
• Press  key.
Exit menu:
• Press W key.
No. Programmable special parameters in lists (F3)
01
CLAMP POSITION RIGHT:
Clamp position right during piece transfer
02
FOLDER SWING RELEASE:
Swing folder
Input of distance (in mm) after which folder swings right after beginning of insertion,
Default 120 mm
03
INSERT SPEED .........:
Clamp insertion speed
04
CLAMP SPEED ..........:
Clamp transport speed
05
WAITING POSITION
Waiting position of clamp behind the end of seam
06
SEWING SPEED 1 .......:
Sewing speed 1 beginning of seam
07
SEWING SPEED 2 .......:
Sewing speed 2 main seam
08
SEWING SPEED 3 .......:
Sewing speed 3 end of seam
09
DISTANCE SEWING SPEED 1:
Distance for slow sewing (sewing speed 1)
10
DISTANCE SEWING SPEED 3:
Distance for slow sewing at end of seam (sewing speed 3)
12
THREAD MONITOR ON AFTER:
Top thread monitor on (distance in mm after beginning of seam)
13
TOP THREAD MON. FILTER:
Filter for top thread monitor (response delay)
14
BOTTOM THREAD MON. FILTER:
Filter for bottom thread monitor (response delay)
16
TACKING LENGTH SEAM BEG:
Initial bar tack length only for lock stitch