Beisler 2211-5 - Manual (Page 81)

- D 81 -
Short Seam Automat 2211-5 Working Instructions Beisler Automated Sewing Equipment
D.3
Programming
„ „ „ „ „ Drive assistance transport to service position
To get sufficient space for works on the sewing head, the
assistance transport can be driven to the outer service
position.
• Press  key.
Z
Return to start position:
• Press  key.
Z
„ „ „ „ „ Manual actuation of the thread clamp:
After the top thread has been passed through the need-
le, the thread clamp is actuated manually to protect the
top thread from being pulled out of the needle when a ma-
chine cycle starts.
• Press  key.
D.3.2 Service menu start level
„ „ „ „ „ Photocell correction for end of seam, seam length
and fixed seam end point:
The settings control the end of the seam. They refer to the
currently selected seam and are in close relation to the
settings made using function F2 for the beginning of the
seam.
The menu has two setting options:
•
the photocell response delay for the end of the seam,
• the setting of the overall seam length.
Photocell response delay:
To set the response delay of the photocell, the correspon-
ding function "Photocell for end of seam" must be enab-
led (see Section D.3.9). The higher the input value, the
later the sewing process stops.
Seam length:
If the function "Photocell for end of seam" is disabled, the
end of the seam is controlled by a fixed seam length. For
this purpose, the function "Sewing to fixed seam end po-
sition" must be enabled (see Section D.3.10). The setting
therefore refers to the seam length to be fixed. The hig-
her the input value, the longer the seam.
• Press  key.
The cursor automatically marks the variable value.
To change this value gradually:
• Press . or Y key.
Enter a completely new numeric value:
• Enter numbers using numeric keypad.
Confirm input and exit menu:
• Press W key.
NOTE - Checking settings!
The settings must be checked using a sewing piece;
if required, they must be corrected.