Beisler 2211-5 - Manual (Page 51)

- C 51 -
Short Seam Automat 2211-5 Working Instructions Beisler Automated Sewing Equipment
C.5
Maintenance
Fig. 13
Fig. 13
C.5.5 Machine set-up
Assistance transport stamp pressure adjustment:
Fig. 13: Check to see if the stamps 4 exerts pressure
onto the sewing piece evenly along the entire length of the
transport section. Line up a piece of fabric to the inserti-
on position and lower the stamps.
Check stamping pressure by trying to pull the sewing piece
out of the stamps at several locations along the transport
section. If the stamping pressure must be adjusted:
1. Adjust pressure at the pressure reducer 3 to 1 bar
(0,1 mpa).
2. Check parallel alignment of the stamps 4 to the slide
plate of the working plate. If the alignment of the stamps
must be adjusted:
3. Loosen the four retaining screws 1.
4. Adjust height position of the complete assistance trans-
port 1.
5. Tighten retaining screws 1.
6. Recheck pressure with completely lowered stamps
along the entire length of the transport section.