Beisler 2211-5 - Manual (Page 41)

- C 41 -
Short Seam Automat 2211-5 Working Instructions Beisler Automated Sewing Equipment
C.3
Start-up
C.3.1 Machine table alignment
After the machine has been installed at the desired loca-
tion, the machine table must be aligned:
•
Set machine table to required height.
• Align machine table horizontally on all sides.
Setting table height:
1. Fig. 1: Lift machine: Connect lifting device at lift points
(arrows) below the crossmembers. If the machine is
equipped with optional transport rollers, release bra-
kes before lifting.
2. Fig. 2: Loosen lockscrews 2 on all guide rails.
3. Pull table legs 3 out to the desired length and retigh-
ten lockscrews 2.
4. Lower machine to floor.
Horizontal positioning of the machine table:
1. Place bubble level onto working plate.
2. Fig. 2: Loosen table leg lock nuts 1.
3. Align machine table horizontally on all sides by raising
or lowering table legs as required.
4. Retighten table leg lock nuts.
NOTE - Shipping braces!
Before the machine is connected to the power sup-
ply system, all shipping braces must be removed.
•
Cut off cable ties.
• Remove labels.
Fig. 1/2
Fig. 1
Fig. 2