Beisler 2211-5 - Manual (Page 44)

- C 44 -
Short Seam Automat 2211-5 Working Instructions Beisler Automated Sewing Equipment
C.4
Operation and shut-down
C.4.1 Working with the machine
Factory setting
The program control of the machine is programmed at the
factory with a sewing program with three different seams.
Factory settings
The machine comes with a factory-installed standard pro-
gram M 01 with three seams (01, 02, 03):
•
Seam 01: Clipping and crimping over of the left slash
selvage with subsequent sewing of the slash selvage
to the left trousers component.
• Seam 02: Sewing the slash selvage to the right trou-
sers component.
• Seam 03: Test seam that is restricted to two functions:
• Clamp movement from the insertion station to the
sewing head,
• Starting/ending the complete sewing process.
The test seam is used for checking the clamp trans-
port and the sewing process when the machine is set
up.
The standard program M 02 works with the two seams (11
and 12).
•
Seam 11: Controls the procedure for sewing the side
pocket to the right trousers component.
• Seam 12: Controls the procedure for sewing the side
pocket to the left trousers component.
The standard program M 03 works with the two seams (19
and 20).
• Seam 19: Controls the procedure for sewing the
right slash selvage to the right trousers compo-
nent at ladies' trousers.
• Seam 20: Controls the procedure for sewing the
left slash selvage to the lefttrousers component at
ladies' trousers.
C.4.2 Machine shut-down
When the machine is to be shut down, it must be discon-
nected from all supply sources.
Disconnecting the machine from the power supply
system:
1. Turn machine off using main switch. Move switch to
position 0.
2. Remove power plug from socket and protect it from
accidental reconnection.
Disconnecting the machine from the compressed air
supply system:
1. Shut off on-site compressed air.
2. Remove compressed air hose plug from terminal unit.
NOTE - Dust-proof protection!
If the machine is to be shut down for an extended pe-
riod of time, it should be covered with a plastic tarpau-
lin.