IDK GF-100 - Manual (Page 28)

GF-100 User’s Guide
28
6.3.1 Beep for source status change
Menu
TOP → SETTINGS → SOURCE LOG → BUZZER
Set value
OFF: The beep does not sound [Default]
ON: The beep sounds when the source status changes.
Note: If “10.5.2 Beep sound (P.58)” is set to “OFF”, it does not sound.
6.3.2 Escape sequence of source status
Letter color code and BELI code are added to the terminal software.
Menu
TOP → SETTINGS → SOURCE LOG → ESCAPE CODE
Set value
DISABLE
ENABLE: The changed status will be shown in red, and warning tone is output from the software every
time the source status changes [Default]
6.3.3 Wait time for detecting source status
The GF-100 waits to detect status of the source device until the status is stabilized.
If you want to detect momentary changes, set the value set this menu to “NO WAIT” or a small value.
If you do not want to detect unnecessary information, set this menu to a larger value.
Menu
TOP → SETTINGS → SOURCE LOG → DETECT WAIT
Set value
NO WAIT
100ms to 10000ms [Default: 800ms]