MBM Corporation 352SA automatic air suction folder with Register System - Manual (Page 25)

Operator's Manual multimaster CAS 35 PBA Fold Unit
26 Mathias Bäuerle GmbH
Positioning the
Fold Plates Mount the fold plates in such a way that two cut-outs (1, 2) each engage in the dowel
pins located on the side plates of the fold unit.
After mounting the fold plates, check
that all pins are engaged properly by
manually turning the fold rollers
(no resistance should be felt).
Electrical Connection
of Fold Plates The electrical connection is done by means of
special 90° plugs.
They are inserted in the respective receptacles of
the fold unit (3) and secured by tightening the
threaded sleeve.
!
Make sure that the main switch is OFF before pulling or inserting
the plug!
Setting Elements
of the Fold Plates By turning the knurled screw (4) it is possible
to make angle corrections of the paper stop,
for example if the paper is out-of-square.
1
2
3
3
4
Setting the Fold
Lengths Setting the fold lengths and closing the deflectors is controlled by the computer.
The respective commands are entered on the operator panel (see paragraph 12,
Automatic Setting).