MBM Corporation 352SA automatic air suction folder with Register System - Manual (Page 63)

Operator's Manual multimaster CAS 35 PBA Perforating - Scoring - Slitting
64 Mathias Bäuerle GmbH
Installation of the
Tools The delivery rollers and a square shaft must be removed for the installation and
removal of the perforating-, scoring- or slitting tools.
• Pull the shaft with the delivery rollers
towards you.
• Push the square shaft (1) against the spring (2)
and disengage it from the mounting hole in
the side plate.
Install in reverse order.
The perforating-, scoring- and slitting tools may be positioned anywhere on the ejector
shaft. To determine the correct position, run an unfolded sheet through the fold unit by
turning the handwheel and marking the correct position of the tool on the sample
sheet.
The perforating-, scoring- and slitting tools are installed as follows:
• Loosen the two Allen screws (3) on the perforating-,
scoring- or slitting tools. The screws are secured
against loss.
Now it is possible to separate the two parts of the tools.
• Connect both parts of the tool on the upper (4) and
lower (5) ejector shaft.
• Slightly tighten both Allen screws.
• Slide the assembled tool to the exact location on
the ejector shaft.
• Tighten both Allen screws (3).
When perforating and slitting, the paper -
especially light paper grades - may stick
to the knife.
Install a stripper (6) to prevent this from
happening.
The stripper should be located as close as
possible without touching it.
1 2
3 3
3
3
4
5
6