MBM Corporation 1500S User Manual
Page 25
25
(2) Skewed to the left
(a) Loosen Thumb Screw and slightly turn Feed Roller Direction Adjustment Dial
clockwise. Tighten Thumb Screw again.
(b) Press Test Key and check 2nd sheet if there is still any skew.
(c) Repeat (a) and (b) above and any skew should be corrected by Feed
Roller Direction Adjustment Dial.
17. After skew is corrected, make trial fold of 10 sheets and make sure that obviously apparent skew is not found for
2nd sheet till 10th sheet. Note 1st sheet is not checked because it is folded before machine is in stabilized motion.
Note:
When folding line does not match as desired, it is required to adjust the stopper position of Table 1 or Table 2.
(Refer (A) Fine Adjustment page 28.)
When double feed occurs or paper is not fed, it is required to adjust air blow strength and paper height.
(Refer to (C) Air adjustment of page 37 or (D) Paper height adjustment of page 38)
9. Start folding
Continuous folding:
When the START / STOP key is pressed, the machine
will continuously fold.
When the START / STOP key is pressed while the
machine is in operation, the machine will stop, but addition on
the counter will continuous.
If you wish to fold only the number of sheets desired,
use the subtraction counter function.
STRAT/STOP key
Skewed to left
Upper side when paper was placed
on Feed Table
Leading Feed Edge