MBM Corporation 1500S - Manual (Page 37)

37
(C) Air Adjustment
[Air Blow Strength Adjustment]
The air blow strength can be adjusted
by turning the air adjustment knob from low, per finer line,
to high, per thicker line.
General information:
When double feed occurs, turn the air adjustment knob
towards lower position slightly.
When paper is not fed, turn the air adjustment knob
towards higher position slightly .
Note: Do not change position of Air Adjustment Knob extremely
From the original position.
13. Press Test Mode Key for more than 2 seconds until buzzer sounds.
Then air starts to blow without feeding paper and Paper Feed Table Rises.
14. Adjust Air Blow Control Knob so as that the top 7 to 10 sheets flies
in the air with stability/steadily and without sticking two
sheet together. Dial is set more or less at fine line (week blow)
as right picture.
15. Press Test Key again and two sheets come out with single fold.
NOTE: (1) By pressing Test Key during blow test mode, machine test folds and automatically goes out of
blow test mode.
(2) Or, by pressing START/STOP Key, blow test mode ends.
5
4
3
2
1
Air Adjustment Knob
Air Blow Control Knob
Weakest
Weak
Midium
Strong