Microcom LDSII - Manual (Page 105)

Chapter 6 Diagnostics and Troubleshooting
LDSII Programming Guide - 880015-0123 89
6.4.16 >FLASH MEMORY LOW< (B0)
The “>FLASH MEMORY LOW<” response indicates that the user storage area of the flash
memory is 95% full while in text and verbose response sets. This message will continue to
be received until files are removed from flash memory or until the printer performs garbage
collecting and defragmenting. If the printer is configured for byte responses, the code ASCII
0xB0 will be issued from the printer in response to an enquiry command.
6.4.17 >BUTTON 1 TAPPED< (C0)
The “>BUTTON 1 TAPPED<” response occurs when the ^D541) command is configured for
the “tapped” response while in text and verbose response sets. This may be used for
custom configuration and definition of the print button press or tapped condition. If the
printer is configured for byte responses, the code ASCII 0xC0 will be issued from the printer
in response to an enquiry command.
6.4.18 >BUTTON 1 HELD< (C1)
The “>BUTTON 1 HELD<” response occurs when the ^D541) command is configured for
the “held” response while in text and verbose response sets. This may be used for custom
configuration and definition of the print button held condition. If the printer is configured for
byte responses, the code ASCII 0xC1 will be issued from the printer in response to an
enquiry command.
6.4.19 >TEMPERATURE OUT OF RANGE< (D0)
The “>TEMPERATURE OUT OF RANGE<” response indicates that the printer’s print head
is not within the proper operating range while in text and verbose response sets. This
response will not allow the printer to print until the print head returns to the proper operating
range. If the printer is configured for byte responses, the code ASCII 0xD0 will be issued
from the printer in response to an enquiry command.
6.4.20 >NONEXISTENT COMMAND< (D1)
The “>NONEXISTENT COMMAND<” response indicates that the printer has received data
in the LDSII command structure that does not exist or is yet to be implemented while in text
and verbose response sets. If the printer is configured for byte responses, the code ASCII
0xD1 will be issued from the printer in response to an enquiry command.
6.4.21 >INCOMPLETE COMMAND< (D2)
The “>INCOMPLETE COMMAND<” response indicates that the printer has received a
command that does not contain all of the required parameters for proper operation while in
text and verbose response sets. If the printer is configured for byte responses, the code
ASCII 0xD2 will be issued from the printer in response to an enquiry command.
6.4.22 >ZIP FILE ERROR< (D3)
The “>ZIP FILE ERROR<” response indicates that the printer has received a zip file that is
either not complete or that the file contains errors while in text and verbose response sets.