Microcom LDSII - Manual (Page 107)

Chapter 6 Diagnostics and Troubleshooting
LDSII Programming Guide - 880015-0123 91
6.4.30 >FONT/GRAPHIC NOT FOUND< (DC)
This enquiry response typically indicates that a font being specified a script file does not
exist in flash memory. If the printer is configured for byte responses, the code ASCII 0xDC
will be issued from the printer in response to an enquiry command.
6.3.31 >SWITCH 0 ACTUATED< (E1)
This enquiry response typically indicates that switch 0 is actuated while in text or verbose
response sets. If the printer is configured for byte responses, the code ASCII 0xE1 is
issued from the printer in response to an enquiry command.
6.3.32 >SWITCH 1 ACTUATED< (E2)
This enquiry response typically indicates that switch 1 is actuated while in text or verbose
response sets. If the printer is configured for byte responses, the code ASCII 0xE2 is
issued from the printer in response to an enquiry command.
6.3.33 >SWITCH 2 ACTUATED< (E3)
This enquiry response typically indicates that switch 2 is actuated while in text or verbose
response sets. If the printer is configured for byte responses, the code ASCII 0xE3 is
issued from the printer in response to an enquiry command.
6.3.34 >TOF SWITCH ACTUATED< (E4)
This enquiry response typically indicates that the Top-Of-Form (TOF) switch is actuated
while in text or verbose response sets. If the printer is configured for byte responses, the
code ASCII 0xE4 is issued from the printer in response to an enquiry command.
6.4.35 >FIELD OFF IMAGE< (F0)
The “>FIELD OFF IMAGE<” response indicates that a fields size and placement coordinates
will not allow the field to fit on the print image or script layout while in text and verbose
modes. The given field that is being placed off the image will not be printed on to the
media. If the printer is configured for byte responses, the code ASCII 0xF0 will be issued
from the printer in response to an enquiry command.
6.3.36 >GRAPHIC TOO LARGE< (F2)
This enquiry response indicates that the graphic sent to the printer is larger than the
available memory while in text or verbose response sets. If the printer is configured for byte
responses, the code ASCII 0xF2 is issued from the printer in response to an enquiry
command.
6.4.37 >POWERED DOWN< (FF)
The “>POWERED DOWN<” response indicates that the printer’s power has been
interrupted while in text and verbose modes. If the printer is configured for byte responses,
the code ASCII 0xFF will be issued from the printer in response to an enquiry command.
This message also indicates that the printer was successful writing pending updates to flash
on a power loss situation.