Microcom LDSII - Manual (Page 57)

Chapter 2 Printer Commands
LDSII Programming Guide - 880015-0123 41
the “^D394)1” command. This command is a “property” which means that it controls a
specific distance that is set at the factory. The property commands may be set back to their
default values using the “^D392)1” command.
2.5.17 ^D647)dc,dp
(Set Print Head Parameters)
The “^D647)” command is used to identify and specify the values for the print head installed
on the printer. The “dc” parameter specifies the “dot count” or total number of dots on the
print head while t
he “dp” or “dot pitch” identifies the dots per millimeter value. This
command is available in all access modes with the exception being LOCKOUT mode only.
This command is typically set at the factory and never changed. Refer to the following table
for the available print heads and their appropriate values.
This command is a “property”
which means that it controls a specific distance that is set at the factory. The property
commands may be set back to their default values using the “^D392)1” command.
Print Head Part
Number
Printer Model
Number
dc
Parameter
dp
Parameter
630015-0000 226 – 203 DPI 406 8
630018-0000 326M – 203 DPI 640 8
630021-0000 326M
– 300 DPI
960 11.808
630020-0000 426M
– 203 DPI
832 8
630019-0000 426M – 300 DPI 1280 11.808
630014-0000 426
– 203 DPI
832 8
630017-0000 426
– 300 DPI
1280 11.808
Table 7 Print Head Parameters
2.5.18 ^D648)n
(Set Blackline Sensor to Print Head Distance)
The “^D648)” command is used to set the blackline sensor to print head distance at the
factory.
This command is a “property” which means that it controls a specific distance that
is set at the factory. The property commands may be set back to their default values using
the “^D392)1” command.