Microcom 470 User Manual
Page 114
Quick Reference Command Summary
Appendix D
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
470 Operators Manual
106
39
Auto-Size Label: Section 5.3.3.
0
Clears the use of auto-size values set by ^A1^D39.
1
Uses the values obtained instead of those in the format file.
2
Automatically sizes the label and send the results out the serial port.
3
Same as ^A2^D39, but prints the values on a label, instead of on the screen.
40
Clear Commands 41-51.
XX
41
Load number of fields in layout (HFM): Preceded by ^A.
XX
42
Load label width in dots (LSX): Preceded by ^A.
XX
43
Load label height in dots (LSY): Preceded by ^A.
XX
44
Load web size in dots (WEB): Preceded by ^A.
XX
45
Load gap size in dots (GAP): Preceded by ^A.
XX
46
Load print speed (DPS): Preceded by ^A.
XX
47
Load label control byte (LCB): Preceded by ^A.
XX
48
Load number of steps to activate gap detector (AGD): Preceded by ^A.
XX
49
Load number of steps past gap (SPG): Preceded by ^A.
XX
50
Load X direction offset (OFX): Preceded by ^A.
XX
51
Load Y direction offset (OFY): Preceded by ^A.
XX
54
Send Non-Volatile Format File to Serial Port: ^A selects which the file to be
sent (1-32). Section 5.3.6.
XX
55
Select Default Label Layout: Select from the ROM power-up layouts. ^AXX
ranges from 1 to 8.
56
End User Defined Field Definitions: Tells the printer that all field definitions are
complete.
57
Enter Label Format Mode: This tells the printer that information for a label is
following.
XX
58
Process Non-Volatile Format: ^A selects which one (1-8). Section 5.3.6.
XX
59
Save Format File: ^A selects which one (1-8). Section 5.3.6.
60
Clears command 61