Microcom 470 User Manual
Page 57
Chapter 5
Printer Commands
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
470 Operators Manual
49
^A
^D
Command
XX
36
Adjust Contrast Base: Use this command to adjust/calibrate the default
contrast. Since the non-permanent ^D35 command is used to control the
darkness in a format file, the ^D36 command is offered to correct any contrast
differences that may exist between different printers while using the same
format file. This command is non-volatile and only needs to be sent once. Do
not include this command inside a format file as it will also change the base print
contrast of every other format printed. Use the ^D35 command to make
temporary adjustments inside a format file. This command has a range of 10 to
200 in increments of 1.
5.3.2 PRINTING COMMANDS
The following commands initiate label printing or define the number of labels to be
printed.
^A
^D
Command
3
Print Command: Prints a single label or starts the printing of a batch of labels.
This is usually the last command in a format file. (Equivalent to ^C)
11
Print a Test Label: Prints a label with diagonal lines that is useful in
determining the condition of wear of the print head. (Equivalent to ^K)
12
Print a Blank Label: (Equivalent to ^L)
XX
73
Load copies count: Tells the printer to print a group of labels. Will not
increment serial numbers (use a ^D75). This can, however, be used in
conjunction with ^D75 (load label count) to allow duplicate labels to be made
inside a batch. For example, to make a batch of three serial number labels
before incrementing the serial number. The batch of labels will be printed when
a ^D3 is executed. Therefore, this must precede a ^D3 command. Example
usage: ^A20^D73^D35 - Prints 20 identical labels.
1
74
Infinity Print: Prints a batch of labels but will continue to print until the printer is
turned off or paused. This command is most useful in tag/tear or peel-and-
dispense modes. ^A1 activates this mode. Can be used with serial numbers.
Example usage: ^A1^D74^D35 - prints until printer is turned off or paused.