Microcom 470 User Manual
Page 117
Appendix D
Quick Reference Command Summary
))))))))))))))))))))))))))))))))))))))))))))
))))))))))))))))))))))))))))))))))))))))))))
470 Operators Manual
109
XX
87
Load Increment/Decrement Value Into Memory: Will load and store a step
value into non-volatile user memory. The stored serial number to be affected is
chosen with the XX variable and the actual step value, up to 9 characters, is
entered by following the ^AXX^D875 with the step value surrounded by quotes.
XX
88
Send Serial Number To Serial Port: ^A specifies which stored serial number
(1-16) to send.
XX
89
Send Increment/Decrement Value To Serial Port: ^A specifies which stored
increment/decrement value (1-16) to send.
XX
90
Enter New Combination: Uses user defined 4 digit combination to enter tech
menu instead of default 9999.
XX
91
Load Value for Printer to See Valid Gap. Section 5.3.
92
Test Printer DRAM: Printer will respond by sending a >PASS< or >FAIL<
message out communications port.
93
Load Control Code Recognition Status:
0
Enable control code recognition.
1
Disable control code recognition.
94
Send Non-Volatile User Memory Available: The printer will send the number of
free bytes to the serial port (i.e. >192480<).
XX
95
Load User Defined Steps for Label to Advance:
XX
96
Load Advance Delay: ^A specifies how many milliseconds to delay
repositioning of the label in tag/tear and peel-and-dispense modes.
97
Tag/Tear Operation: Section 2.6.1.
0
Turns off tag/tear operation.
1
Advance after every label.
2
Advance after copies count.
3
Advance when idle.
98
Peel-and-Dispense Mode: Section 2.6.2.
0
Turn off peel-and-dispense mode.
1
Turn on peel-and dispense mode.
XX
101
Load Graphic Image into Non-Volatile User Memory: ^A select which volatile
slot to place the image in (1-16).
XX
102
Load Volatile Graphic Image: ^A select which volatile slot to place the image in
(1-16).