MMD Equipment 25S-3A3 - Manual (Page 33)

5. Operation
5-3
Fire prevention
Taking off the radiator cap
5.1.3 Check Coolant Level
Be sure to stop the machine and allow time to cool. Loosen the
radiator cap one notch. After the coolant water is sufficiently
cooled and the inner pressure is released, slowly remove the
cap.
If this procedure is neglected, the inner pressure can blow the
cap off. Steam jetting out of the radiator could result in a
serious scalding injury.
Check the coolant level in the reserve tank. If it is lower than
the limit, open the cap and replenish the coolant. (Level must
be kept above LOW mark.)
If little coolant is left in the reserve tank, replenish the
radiator with coolant. (See 6.9.1)
5.1.4 Check Fuel
Do not, under any circumstance, smoke cigarettes or
light matches during fueling.
Fuel is extremely flammable and dangerous. It is,
therefore, very easy to start a fire when you handle fuel
around flames or sparks.
Refuel only after stopping the engine, and never leave
an open fuel can near the machine. Do not spill. It could
cause a fire. If fuel is spilled, clean it up completely.
Fuel refilling should be done in an outdoor
well-ventilated area.
Be sure to use diesel fuel oil for diesel engine.
(Using other oils may cause low power or damage to the engine.)
Check fuel gauge for low level before operation. Replenish enough fuel to prevent fuel
shortage during operation.
Be sure to fasten the fuel tank cap firmly after refilling. If fuel is spilled, clean it up
completely.
D004
H990432
SG0122
Choose appropriate fuel
Low
Reserve tank