MMD Equipment 25S-3A3 - Manual (Page 43)

6. Periodic Inspection/Maintenance
6-1
6.1 Important Items at Periodic Inspection and Maintenance or after Maintenance
The manual shows proper intervals for periodic inspection and maintenance under normal
operating conditions. Inspection and maintenance should be performed more often under
extremely harsh conditions.
Remove the starter key from the starter switch before
inspection, and hang up a "Now Checking and under
Maintenance" tag where it can be easily seen. The
service person must keep the key during checking and
maintenance.
Remove the negative (-) side cable from the battery.
This will prevent accidental starting of the machine
should another person not realize maintenance is being
performed.
Be sure to use appropriate tools for inspection and maintenance work. Inappropriate tools
could cause unexpected injury.
Place a container or a pan underneath the oil drain port to receive waste liquid so that such
liquid cannot be spilled on the ground or inside the unit.
Do not discharge waste materials onto the ground and/or into the river and lake. Such liquid
will contaminate the environment.
Be sure to use recommended fuel, oil, grease, and antifreeze.
Do not disassemble or adjust engine, generator main body, or part(s) for which inspection or
maintenance is not referred to in this manual.
Use only genuine parts for replacement.
Any breakdown caused by not using genuine parts or by misuse, will be out of the scope of
“WARRANTY”.
Keep the generator electric components away from water or steam.
Hang a “Now Checking and under Maintenance” tag
Precautions for check and maintenance
SY001