3 adjusting controller for automatic starting, Maintenance/adjustment – MMD Equipment 25S-3A3 User Manual

Page 59

Advertising
background image

7. Maintenance/Adjustment

7-2

7.2.3 How to Use Jumper Cables


If a jumper cables has to be used or when cables are connected at battery replacement, be

careful not to connect (+) and (−) terminals backwards. Such a miss-connection will causes

a spark or damage to each component.

(Procedure for using a jumper cable)

Stop the engine.

Connect one end of the (+) cable to the (+)
terminal of the machine battery.

Connect the other end of the (+) cable to the (+)
terminal of the external battery.

Connect one end of the (−) cable to the(−)
terminal of the external battery.

Connect the other end of the (−) cable to the
engine block of the machine.

Start the engine.

Disconnect the booster cable by following the
procedure in the reverse order.






7.3 Adjusting controller for automatic starting


It is not necessary to adjust the controller in an usual case which is pre-adjusted prior to

shipment from factor. Never change the set value of the controller.

If you operate the unit with the set value altered, it could cause burns and damage to the parts

and components

.


For a controller , please contact our distributor or directly us

.



Do not connect the cable reversely

H990050

Connect to the engine block of the unit

Machine battery

External battery(12V)

Advertising
This manual is related to the following products: