MMD Equipment 25S-3A3 - Manual (Page 7)

1.Safety
1-4
Use the lifting bail (1) in the center of bonnet for hoisting up
and down the machine. Since the rope hook (2) in not strong
enough to be used for hoisting, never use it to prevent falling
accident.
When transporting the machine, be sure to put it on the truck
bed and use the rope hooks to secure it with rope(3) in the
center of bonnet. Apply chocks(4) to fix the machine on the
truck bed when necessary.
Select an appropriate crane and truck by referring to the mass
and dimensions shown in “Specifications” in Chapter 9.
Only the qualified crane operator is allowed to operate a crane.
Do not hoist up the machine while it is running. Otherwise, a
fatal trouble or serious accident may occur to the machine parts.
The machine must be installed on dry, firm and level area.
In case the machine has to be installed on a slope, keep
the inclination angle less than 5 degrees.
Avoid installing the machine in a place such as a damp
area or a place where puddles might form after rain. Such
an installation could cause electric shock.
Do not direct the exhaust gas outlet to nearby personnel or
houses in the vicinity.
When installing the machine at salt water areas or on a ship,
make sure the machine is not exposed directly to sea water.
When installing the machine at sandy areas, make sure that
exhaust from the generator or radiator does not blow the
sand in the air, or into the machine.
The machine should be operated in following conditions:
Ambient temperature 5°F to 104°F
( –15℃ to +40℃)
Humidity Less than 85%
Altitude Lower than 1,640ft (500 m) above sea level
Transportation
Installation
SG0103
3
4
2 1
SG0102