MMD Equipment 25S-3A3 - Manual (Page 34)

5. Operation
5-4
5.1.5 Drain Fuel Tank
Open drain valve at the bottom of the fuel tank to
discharge condensation left in the tank.
With condensation completely drained, firmly close
the drain valve.
Dispose of properly according to designated
regulations.
5.1.6 Check Condensation in Water Sedimenter
Check if the red float in the water sedimenter rises up to the water drain level, mark drain
water if it is near the maximum drain level.
(1) SDG25S
(Procedure)
① Close the valve lever on the upper part of the
sedimenter.
② Loosen the ring nut to remove the bowl.
Carefully remove the bowl because it contains fuel.
Be careful not to spill fuel and soil the machine
interior.
③ After draining condensation, clean the bowl, and
re-install.
④ Turn the valve lever to "OPEN" position to refill fuel
and bleed air. (See 5.5)
(2) SDG45S/60S/75S/100S
(Procedure)
① Loosen the drain plug to drain the water from the
sedimenter.
② After draining condensation, fasten the drain plug
securely.
SDG25S
SG0124
Drain level
Float (red ball)
Drain plug
CLOSE Valve lever
Ring nut
Drain level
Float(red ball)
H990046
OPEN
H990309