Montigo H36PVN - Manual (Page 25)

H36PVN Power Vent Indoor Gas Fireplace
Page 25
XG0649 - 031511
Installation
Section 7: Installing & Removing the Door
Section 7: Installing & Removing the Door
Removing the doors:
The doors are removed in a few simple steps .
Follow the steps below to remove the Vertical Door trim, place the
Door removal tool, and then remove the door . Replace all the parts
in reverse order .
Step 1. Remove the two (2) Vertical Trim pieces, (LH & RH) . Pulling
firmly with your fingers, remove from the bottom then the top . (See
Figures 17 & 17a) . Other side Typical .
Figure 17. (Remove LH Trim) Figure 17a. (Remove RH Trim)
Step 2. Remove the supplied glass lifting tool from the packaging .
Place in the center of the Glass door as shown, and activate the
suction feature of the tool, Figure 17b . NOTE: Read ALL the instruction
supplied with the tool, and follow the associated operating procedures .
Figure 17b. Supplied Glass lifting tools.
To install the door, follow Steps 1 and 4 above, (in reverse order) . Hook
the top edge of the door frame into place . Lower and rest the door
frame in place and fasten the buckles . See figures 28a and 28b .
Installing the Door:
Figure 17c . (Lift the door
upward)
Figure 17d . (Lift the bottom of
the door outward) .
Figure 17e.
Step 3. Hold the Glass Removal Tools firmly, Lift the door upward,
into the top door frame, Figure 17c . Then pull the bottom of the glass
door downward, and tilt outward from the bottom fireplace door frame .
Figure 17d . NOTE: Read ALL the instruction supplied with the tool,
and follow the associated operating procedures .
Step 4. Still holding the Glass
Removal Tool firmly, remove the door
outward, and away from the Fireplace,
Figure 17e .
Step 5. Place the door in a safe
location while maintenance, cleaning
or other operation are in progress .
NOTE: Read ALL the instruction
supplied with the tool, and
follow the associated operating
procedures.
Step 6. To replace, See Installing
the Door, Below.
Lift Upward into
the door frame.
Lift Downward
& away from frame.
Do not use ammonia based or abrasive
cleaners on the glass, they will
permanently etch the surface. Use an
approved gas fireplace glass cleaner
such as Kel-Kem or White off.
NOTICE
XW2000