Omnia Audio Omnia.9/XE - Manual (Page 62)

Multiband Thresholds Menu
The Multiband Thresholds menu allows you to set the target for each of the Multiband AGC bands as
well as the threshold for each band of the Multiband Limiters. The total number of bands available in the
Multiband Thresholds section is determined by the number of bands of processing used in the Current
Preset.
• The AGC Target controls set the target output level of each band of the Multiband AGC. A lower
setting provides a lower output level, while a higher setting provides a higher output level. These
controls have a range between +12 and -12dB in one-tenth dB increments.
• The Limiter Threshold controls determine at which point the Multiband Limiter acts upon the
incoming audio for its particular band relative to its corresponding AGC Target. For example, a
setting of +6dB means that any peaks of less 6dB above the AGC Target level will not be processed
by the limiter. These controls have a range between +18 and 0dB in one-tenth dB increments.
Wideband AGC2 Menu
The Omnia.9/XE’s Wideband AGC2 control allows you to insert one additional AGC processing stage into
the chain as outlined in detail below.
The Wideband AGC2 menu provides access to the transient enhance, maximum gain, maximum gain
reduction, ratio, attack, release, progressive release, target, gate threshold, freeze threshold, and three-
band sidechain parametric equalizer controls.
• The Bypass button removes the Wideband AGC1 compressor from the audio path, but its patch
point remains an available option for viewing on the oscilloscope or RTA via the Display Settings
menu.
The Station Menu - Processing Menu
62