OpenEye SW-RWTCP - Manual (Page 15)

27314AI 15
INSTALLATION & CONFIGURATION
RETALIX NCR CONFIGURATION
Retalix NCR ScanMaster Server Side Setup
1. Register the Windows user DVRAdmin with the password dvr4321 on the Retalix ScanMaster Server.
2. Give DVRAdmin full access privileges to the scan1dos share on the Retalix ScanMaster Server.
DVR / NVR Server Side Setup
3. Click Setup on the Main Display screen of the DVR or NVR Software.
4. Click General in Setup.
5. Click the POS Setup button to open the POS Setup window.
6. Click the Setup POS Agent button in the POS Setup window to open the Communication Status window.
7. Set the Protocol to Retalix in the Communication Status window and click Setup.
8. In the Save tab select the Save Location and configure the other save options then click Apply.
Note: The default option – C:\ drive – is the recommended save location.
9. Click the Communication tab and set the POS ID to the register number you are connecting to and the Type as File. Click Add
to open the File Community window.
10. In the File Community window, click the Map Network Drive button to open the Map Network Drive window.
11. In the Map Network Drive window confirm that the Reconnect At Logon checkbox is selected, set the Drive to “Z:\” and the
Folder to “\\[ip address of ScanMaster server]\scan1dos”. Click Finish.
12. In the File Community window click the Browse button to open the Browse for Folder window and select
Z:\ > Grocery > Files then click OK.
13. Enter the Register number you are connecting to in the File Extension Name box (e.g. Register 1 is 001) and click OK.
14. Repeat steps 9, 12, and13 until all registers have been added then click the Apply and OK buttons.
15. Under the Communications tab in the Option window select the POS ID just added and click the Rules button. Select User
Define and enter the last item found on EVERY receipt printed, then click OK. (This updates the RediWatch POS Database with
current receipt information.)
CAUTION: Failure to properly define the last item printed (ex: phone number or address) will result in improperly recorded
data.
16. Click OK to save the current settings and exit the Option window.
17. Click OK to close the Communications Status window.
18. In the POS Setup window select a camera under Channel and assign it a register under POS.
19. Repeat step 18 until all registers have been assigned to a camera.
20. Click OK to save the current setting and close the POS Setup window.
21. Click Exit in the Setup menu to return to the Main Display.
22. Incoming transaction data should now be displayed on cameras with registers assigned to them.