In-room installation configuration – OpenEye SW-RWTCP User Manual
Page 31
27314AI
31
IN-ROOM INSTALLATION CONFIGURATION
This solution is used only if the OpenEye DVR is located in the data room where the AVE device is located. This solution does not
require the RS-232 to TCP/IP device by Lava as the RS-232 cable run would be minimal.
1. Plug the ATM network cable into the RJ45 IN port on the TCPIP/232 AVE adapter.
2. Use a CAT5 patch cable to connect the AVE adapter and the network switch using the RJ45 Out port.
Note
Use the utility provided by AVE to set the IP address of the AVE TCPIP/232 adapter.
3. After the AVE adapter is placed on the network, configure the box with the same IP address as the ATM machine via a laptop
and a null modem cable using a configuration application.
4. Install a null modem cable between the AVE and OpenEye DVR.
5. Configure the DVR to display transactions using the instructions for RS-232 Based POS Configuration in this manual.