OpenEye SW-RWTCP - Manual (Page 30)

30
AVE ATM CONFIGURATION
NETWORK INSTALLATION CONFIGURATION
1. Plug the ATM network cable into the RJ45 IN port on the TCPIP/232 AVE adapter.
2. Use a CAT5 patch cable to connect the AVE adapter and the network switch.
Note Use the utility provided by AVE to set the IP address of the AVE TCPIP/232 adapter.
3. After the AVE adapter is placed on the network, configure the AVE box with the same IP address as the ATM machine via a
laptop and a null modem cable using a configuration application.
4. Add the Lava serial to TCP/IP device to the network with its own IP address.
The Lava serial to TCP/IP device is used to run RS-232 a long distance, without extra cabling, on an existing network.
5. Install a null modem cable between the AVE and Lava adapter.
6. On the OpenEye DVR, configure a virtual serial port that uses the Lava serial device.
Refer to the instructions for the Lava device for more information.
7. Configure the DVR to display transactions using the instructions for RS-232 Based POS Configuration in this manual.
Notes Full account numbers are displayed by default. The AVE device needs to be configured to mask the account number to only
show the last 4 digits. AVE says this can be done with a filter from the TCP/IP adapter configuration. This may require some
trial and error to configure correctly.