OpenEye SW-RWTCP - Manual (Page 29)

27314AI 29
ISS45 CONFIGURATION
Note: The CCTV Bit, Bit 5, must be enabled to output to transactions to DVR system.
Verify HASP Key has CCTV Bit
1. Launch BackOffice.
2. Log in to BackOffice.
3. Select 6 – 1 – 12.
4. Verify 5.CCTV is selected. If it is not selected contact your ISS45 vendor.
Enable Data Output
1. Launch BackOffice.
2. Log in to BackOffice.
3. Select 6-System Maintenance & Utilities.
4. Select 4-Security Maintenance.
5. Select 8-CCTV Parameters.
6. Select the 1. CCTV in System check box.
7. In 2. CCTV Server Host Name, enter the DVR IP address.
8. In 3. CCTV Server Port, enter 200.
9. Press F2.
10. Press ESC three times to save and exit.
DVR / NVR Server Side Setup
1. Click Setup on the Main Display screen of the DVR or NVR Software.
2. Click General in Setup.
3. Click the POS Setup button to open the POS Setup window.
4. Click the Setup POS Agent button in the POS Setup window to open the Communication Status window.
5. Set the Protocol to ISS45 in the Communication Status window and click Setup.
6. In the Save tab select the Save Location and configure the other save options then click Apply.
7. Click the Communication tab and set the POS ID to the register number you are connecting to and the Type as TCP Server.
8. Click Add to open TCP/UDP Communication window.
9. In the TCP/UDP Communication window, enter 200 into the Local Port box.
10. In the TCP/UDP Communication window, confirm that the Match Workstation ID check box is selected and enter the register
ID in the Workstation ID box.
11. Click OK
12. Repeat steps 7-10 until all registers have been added then click the Apply and OK button.
13. Click OK to close the Communications Status window.
14. In the POS Setup window select a camera under Channel and assign it a register under POS.
15. Repeat step 14 until all registers have been assigned to a camera.
16. Click OK to save the current setting and close the POS Setup window.
17. Click Exit in the Setup Menu to return to the Main Display. Incoming transaction data should now be displayed on cameras with
registers assigned to them.