OpenEye SW-RWTCP - Manual (Page 26)

26
RUBY VERIFONE CONFIGURATION
1. Click Setup on the Main Display screen of the DVR or NVR Software.
2. Click General in Setup.
3. Click the POS Setup button to open the POS Setup window.
4. Click the Setup POS Agent button in the POS Setup window to open the Communication Status window.
5. Set the Protocol to Ruby and click Setup.
6. In the Save tab select the Save Location and configure the other save options then click Apply.
Note: The default option – C:\ drive – is the recommended save location.
7. Click the Communication tab and set the POS ID to the register number you are connecting to and the Type as RS-232. Click
Add to open the RS-232 window.
8. In the RS-232 window select the COM Port the Ruby VeriFone is connected to and click OK.
9. Under the Communications tab in the Option window select the POS ID added above and click the Property button to open
the COM Properties window.
10. Configure the communication settings for the Baud Rate the Ruby Printer is set to and click OK. (Default Ruby settings are:
9600, 8, None, 1)
11. Under the Communications tab in the Option window select the POS ID just added and click the Rules button. Select User
Define and enter the last item located on EVERY receipt printed, then click OK. (This updates the RediWatch POS Database
with current receipt information.)
CAUTION: Failure to properly define the last item printed (ex: phone number or address) will result in improperly recorded
POS data.
12. Click OK to save the current settings and exit the Option window.
13. Click OK to exit the Communications Status window.
14. In the POS Setup window select a camera under Channel and assign it a register under POS.
15. Repeat the previous step until all registers have been assigned a camera.
16. Click OK to save the current setting and close the POS Setup window.
17. Click Exit in the Setup menu to return to the Main Display. Incoming transaction data should now be displayed on cameras
with registers assigned to them.