OpenEye SW-RWTCP - Manual (Page 23)

27314AI 23
ACS NCR CONFIGURATION
ACS Server Side Setup
1. Launch the ASW Shell.
2. Click the Store Setup tab.
3. Select Option Editor Maintenance.
4. Click the General Store tab.
5. Set the LAN Capture Data option to YES.
6. Click the Terminal Option tab.
7. Select APPINI.
8. In the LAN Capture section, enter the destination TCP/IP Address in the Address box. The last octet of the address must be set
to broadcast on the current ACS subnet in order for the DVR to see transactions, please see table example below.
a. If ACS subnet is 255.255.255.0 set ip to x.x.x.255
b. If subnet is 255.255.0.0 set up to x.x.255.255
c. If subnet is 255.0.0.0 set ip to x.255.255.255
d. If subnet differs please contact technical support
9. In the LAN Capture section, enter the destination TCP/IP Port in the Port box. If no port is listed enter 199. If you are using a
Catalina Coupon Server DO NOT change the current port setting.
10. Click Save.
11. Activate > Activate Maintenance Option File Set > All Defined Groups > Execute.
12. Close the window and restart the POS Terminal.
DVR / NVR Server Side Setup
13. Click Setup on the Main Display screen of the DVR or NVR Software.
14. Click General in Setup.
15. Click the POS Setup button to open the POS Setup window.
16. Click the Setup POS Agent button in the POS Setup window to open the Communication Status window.
17. Set the Protocol to ACS (NCR) in the Communication Status window and click Setup.
18. In the Save tab select the Save Location and configure the other save options then click Apply.
19. Click the Communication tab and set the POS ID to the register number you are connecting to and the Type as UDP Server.
Click Add to open TCP/UDP Communication window.
20. In the TCP/UDP Communication window, enter the TCP\IP Port used in step 8 into the Local Port box.
21. In the TCP/UDP Communication window, confirm that the Match Workstation ID check box is selected and enter the register
ID in the Workstation ID box.
22. Click OK
23. Repeat steps 19-22 until all registers have been added then click the Apply and OK button.
24. Click OK to close the Communications Status window.
25. In the POS Setup window select a camera under Channel: and assign it a register under POS:
26. Repeat step 25 until all registers have been assigned to a camera.
27. Click OK to save the current setting and close the POS Setup window.
28. Click Exit in the Setup Menu to return to the Main Display.
29. Incoming transaction data should now be displayed on cameras with registers assigned to them.