Orion System SA E-BUS Controller - Manual (Page 68)

Zone
Zone
Index
SA E-BUS Controller Technical Guide 68
O-P
O
Occupied Cooling Mode.........41
Occupied Mode of Operation.........41
OE210.........13
OE211.........13
OE212.........13
OE213.........13
OE213 Space Temperature Sensor.........13
OE217-00 Digital Room Sensor.........12
OE217-01 Digital Room Sensor.........12
OE231 Wiring.........15
OE231 Entering Air Temperature Sensor.........16
OE231 Supply Air & Return Air Temperature Sensors.........14
OE233.........15
OE250 Wiring.........17
OE265-11 Wiring.........25
OE265-11 Indoor Wall-Mounted Humidity Sensor.........25,61
OE265-14 Wiring.........24
OE265-14 Entering Air Humidity Sensor.........61
OE265 RH Sensor Testing.........61
OE271 Pressure Sensor Testing.........62
OE275-01.........22
Wiring.........22
OE275-01 Suction Pressure Transducer
R410A Refrigerant Testing.........63
OE332-23E-SA
Components.........9
Dimensions.........6
Requirements.........10
Wiring.........11
OE332-23E-SA SA E-BUS Controller.........5,11
OE333-23-EM.........10
OE333-23-SA.........5,11,20,30
Dimensions.........7
Input Wiring.........20
Output Wiring.........21
Requirements.........10
OE333-23-SA SA Expansion Module.........30
OE358-23-12R.........10,11,30
Dimensions.........8
Jumper Settings.........30,31
Wiring.........30,31
OE358-23-12R 12-Relay Expansion Module.........20,30
OE370-23-HP2C.........5,34
Requirements.........10
Off Mode.........41
On Board Relay Status (Bit Pattern).........52
Operating Summary.........37
Operation Modes
Cooling Mode.........41
Dehumidifi cation Mode.........41
Duct Static Pressure Control.........48
Forced Schedule.........41
Heating Mode.........41,46
Heat Pump.........41
HVAC Modes.........41
Internal Week Schedule.........41
Morning Warm-Up Mode.........47
Off Mode.........41,47
Pre-Heater Operation.........49
Push-Button Override Signal.........41
Remote Forced Occupied Signal.........41
Supply Fan Control.........48
Vent Mode.........41
Warm-Up Mode.........41
Water Side Economizer.........41
Operator Interfaces.........37,56
Optimal Start Scheduling.........5
Outdoor Air Volume.........5
Output Wiring
SA Expansion Module.........21
Overrides.........53
P
Polarity
Correct.........10,36
Observing.........37
Warning.........37
POWER LED.........54
POWER LED Operations.........54
Power Requirements
Before Applying.........36
SA Controller.........36
Power Wiring.........36
Pre-Heater Operation.........49
Pressure Sensor Testing.........62
Prism Computer Front End Software.........56
Prism Computer Front-End Software.........37
Programming
Controllers.........37
Proportional Inlet Vanes.........39
Push-Button Override
Feature.........38
LED Blinks.........55
Signal.........41