REMKO KWL 130 H - Manual (Page 14)

Care and maintenance Shut-down
Temporary shut-down
1. Shut down the interior units
using the remote control.
2. Shut the unit off over the
internal control in the chiller (or
using the remote control).
3. Check the proportion
(percentage) of glycol.
4. Check the unit for visible signs
of damage and clean it as
described in the chapter "Care
and maintenance".
5. As much as possible, cover the
unit with a plastic foil to protect
it against the weather.
If only water and not a
mixture of water and glycol
is used, in regions subject
to freezing, water must be
drained from components
when these are at standstill.
The drained water volume
must be replaced when
components are put back into
operation!
! CAUTION
Permanent
shut-down
Ensure that equipment and
components are disposed of in
accordance with local regulations,
e.g. using certified firms and
recycling specialists or at collection
points.
REMKO GmbH & Co. KG or your
contractual partner will be pleased
to provide a list of certified firms
near you.
Regular care and observation
of some basic points will ensure
trouble-free operation and a long
service life.
Prior to performing any
work, ensure the equipment
is isolated from the voltage
supply and secured to prevent
accidental switch-on!
! CAUTION
Care
■
Ensure the unit is protected
against dirt, mould and other
deposits.
■
Clean the unit using a damp
cloth.
Do not use a jet of water.
■
Do not use any caustic, abra-
sive or solvent-based cleaning
products.
■
Clean the fins on the unit prior
to long shutdown periods.
Maintenance
■
We recommend
maintenance contract with an-
nual maintenance interval with
an appropriate specialist com-
pany.
This ensures the operational
reliability of your
at all times!
TIP
Type of task
Checks / maintenance / inspection
Commis
-
sioning Monthly Half-yearly Yearly
General •
Clean dirt traps
• •
Check medium filling
• •
Check circulation pump
• •
Dirt / damage condenser • •
Check quality of the glycol • •
Measure voltage and current • •
Check direction of rotation
• •
Check compressor
• •
Check fan
• •
Check refrigerant fill quantity
• •
Check condensation drain
• •
Test insulation
• •
Sealing test for refrigerant circuit
• •
1)
The law requires a leak test of
the cooling circuit with regard
to the quantity of cooling
medium. Inspection and docu-
mentation is to be carried out
by specialty technicians.
NOTE
1) see note
REMKO KWL (H)
14