Sundance SMT702 - Manual (Page 15)

Average Fanout of Non-Clock Nets: 3.00
4.2.2.3 Resources used – XCV5FX70T.
Below is a summary (ISE11.4) of the resources used in the FPGA by the default
firmware (Standard SMT702 – XCV5VFX70T FPGA – PXIe option):
Slice Logic Utilization:
Number of Slice Registers: 15,344 out of 44,800 34%
Number used as Flip Flops: 15,337
Number used as Latches: 1
Number used as Latch-thrus: 6
Number of Slice LUTs: 11,832 out of 44,800 26%
Number used as logic: 11,372 out of 44,800 25%
Number using O6 output only: 9,458
Number using O5 output only: 289
Number using O5 and O6: 1,625
Number used as Memory: 429 out of 13,120 3%
Number used as Dual Port RAM: 308
Number using O6 output only: 204
Number using O5 output only: 20
Number using O5 and O6: 84
Number used as Shift Register: 121
Number using O6 output only: 121
Number used as exclusive route-thru: 31
Number of route-thrus: 393
Number using O6 output only: 318
Number using O5 output only: 75
Slice Logic Distribution:
Number of occupied Slices: 6,261 out of 11,200 55%
Number of LUT Flip Flop pairs used: 19,052
Number with an unused Flip Flop: 3,708 out of 19,052 19%
Number with an unused LUT: 7,220 out of 19,052 37%
Number of fully used LUT-FF pairs: 8,124 out of 19,052 42%
Number of unique control sets: 821
Number of slice register sites lost
to control set restrictions: 1,821 out of 44,800 4%
A LUT Flip Flop pair for this architecture represents one LUT paired with
one Flip Flop within a slice. A control set is a unique combination of
clock, reset, set, and enable signals for a registered element.
The Slice Logic Distribution report is not meaningful if the design is
over-mapped for a non-slice resource or if Placement fails.
OVERMAPPING of BRAM resources should be ignored if the design is
over-mapped for a non-BRAM resource or if placement fails.
IO Utilization:
Number of bonded IOBs: 463 out of 640 72%
Number of LOCed IOBs: 463 out of 463 100%
IOB Flip Flops: 693
IOB Master Pads: 1
IOB Slave Pads: 1
Number of bonded IPADs: 10 out of 50 20%
Number of bonded OPADs: 8 out of 32 25%
Specific Feature Utilization:
Number of BlockRAM/FIFO: 38 out of 148 25%
Number using BlockRAM only: 22
Number using FIFO only: 16
Total primitives used:
Number of 36k BlockRAM used: 21