Sundance SMT702 - Manual (Page 40)

4.3.1.2.12 ADCB (ADC083000) Register 0x1 – Configuration Register
– 0x84 (write and read).
Offset 0x0400 - ADCB (ADC083000) Register 0x1 – Configuration Register – 0x84 (write and read)
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
1 Reserved DRE RTD DCS DCP nDE OV OE
Default ‘1’ ‘1’ ‘0’ ‘1’ ‘0’ ‘1’ ‘1’ ‘0’
0 Reserved Reserved Reserved Reserved Reserved Reserved Reserved Reserved
Default ‘1’ ‘1’ ‘1’ ‘1’ ‘1’ ‘1’ ‘1’ ‘1’
Offset 0x0400 - ADCB (ADC083000) Register 0x1 – Configuration Register – 0x84 (write
and read)
Setting Bit 14 Description (DRE – Differential Reset Enable)
0 0 Single-ended Reset enabled.
1 1 Differential Reset enabled.
Setting Bit 13 Description (RTD – resistor Trim Disable)
0 0 Normal Operation.
1 1 Input termination resistor is not trimmed during calibration cycle.
Setting Bit 12 Description (DCS – Duty Cycle Stabilizer)
0 0 Stabilisation circuit disabled.
1 1 Duty Cycle Stabilizer applied to the sampling clock.
Setting Bit 11 Description (DCP – DDR Clock Phase – DDR Mode only)
0 0 0° phase – ADC output clock time-aligned with data.
1 1 90° phase – ADc output clock placed in the middle of data.
Setting Bit 10 Description (nDE – DDR Enable)
0 0 DDr Mode.
1 1 SRD Mode.
Setting Bit 9 Description (OV – LVDS Output Voltage amplitude)
0 0 Reduced output amplitude – 510mV. This setting is recommended on the SMt702. It
reduces the overall noise on the board and therefore increases the performance of the
ADCs.
1 1 Standard output amplitude – 710mV.
Setting Bit 8 Description (OE –Output Edge)
0 0 1:4 Demux Mode (DDR Mode must be Selected).
1 1 1:2 Demux Mode (DDR Mode must be selected).