Super Systems X5 - Manual (Page 46)

4.5.1 SETPOINT MENU
46
4 - Operation
4.5 PARAMETERS
For a simpler use of the con-
troller, the parameters have been
organ
ized in menus, according
to their functional area.
Setpoint
change
Target Setpoint
= 350
°C
t
t = 10
# sL. u = 10
digit/minute
Example
Initial
Setpoint
= 250
°C
Setpoint
low limit
Setpoint
high limit
High and low limit of the SP.
The minimum span (S.P.L - S.P.H)
must be greater than 100 digit.
Setpoint
ramp up
Setpoint
ramp down
This parameter specifies the
maximum rate of change of the
Setpoint.
Adjustable in digit/s,digit/min
and digit/hour (see page 27)
When the parameter is OFF ,
this function is disabled and
the new Setpoint is reached
immediately after being
entered.
#sl. d
#sl. u
#s.P. H
#s.P. L Otherwise, the Setpoint value is
obtained according to the con-
figured rate of change.
The new Setpoint value is called
"Target Setpoint". It can be dis-
played by means the parameter
#t.S.P.
(see procedure at page 53).
When Remote Setpoint is con-
figured, we suggest to disable
#sl. u and #sl. d parameters
Off .
1st stored
Setpoint
2nd stored
Setpoint
3th stored
Setpoint
Values of the three Setpoints,
that are activated by mean of
logic inputs, communication
parameters, and keyboard. The
Setpoint active is indicated by
the ú, ù or û green LED.
See page 56 for further explana-
tion.
Remote Setpoint
Slope enable
To enable or disable slopes when
the remote Setpoint is active.
#rs.sl
#S.P. 3
#S.P. 2
#S.P. 1
X5-SSI-uk 18-03-2009 17:54 Pagina 46