Super Systems X5 - Manual (Page 57)

57
5 - Displays
5.1 STANDARD DISPLAY
275.0
274.8
63
275.0
274.8
63
rel.
00A
Hard
3150
Out
30.0
t.s.p.
300.0
Op
63.0
°C
274.8
tune
no
s.sel
none
3fs.H
365.8
A B C D
Product
identification
codes
Manual
mode Operator mode
Automatic mode
Fastview
parameters
5 DISPLAYS
Software
release
Base
product code
(see page 5)
Engineering
units
Main output
(during the program
run only)
Target
Setpoint value
local mode only
(not displayed if the
Slopes are disabled)
Virtual valve
position
(0...100%)
One shot
tune start
no /yes
Alarm 3 threshold
(high absolute
alarm)
full scale
Stored Setpoint
selection
none /s.LOC/
s.s.p.I /s.s.p.2/
s.s.p.3
Back to the Operator mode Back to the Operator mode
5.2 FAST VIEW
(fast access to the parameters)
With this procedure, up to 10
parameters, selected through
the fast view (see par 4.6 page
56) are displayed and can be
modified by the operator
without requiring the standard
parameter setting procedure.
Press
$% in order to
modify the parameters.
The value is entered by
pressing
è key.
On left side, please find a
sample list of parameters on
Fast view menu.
X5-SSI-uk 18-03-2009 17:54 Pagina 57