Super Systems 9200 - Manual (Page 21)

Model 9200 Programmable Dual-loop Controller
SSi Manual SERIES 9200 21 Programmable Dual-loop
To activate one or more of the thermocouples, use the blue up and down arrows to highlight the desired
thermocouple then press Enter. This will activate, or deactivate the selected thermocouple.
Port Setup
Warning: Changes to this screen should not be made without consulting SSi at 800-666-4330.
Highlighting this menu selection and pressing the Enter key moves you to the Port Setup Screen.
Parameter Value
Host 232 Baud
TPC-642S
Host 232 Mode Modbus
Host 485 (3,4) Baud 19200
Host 485 (3,4) Mode Modbus
Host 485 (3,4) Address 1
Slave 1 (5,6) Baud 19200
Slave 1 (5,6) Mode Modbus
Slave 2 (22,23) Baud 9600
Slave 2 (22,23) Mode ADAM
These values can be changed by using the up and down arrow keys to highlight your selection, press the
Enter key. A selection of communication protocols is displayed. Make your selection and press the Enter
key. The Cancel key takes you back to the previous screen without changes being made.
Instrument Setup
WARNING: This screen should not be changed without consulting SSi at 800-666-4330.
Highlighting this entry and pressing the Enter key takes you to a two-level screen. The first level allows
you to select the instrument to setup. To highlight the desired instrument use the first set of blue up and
down arrow keys and then press Enter key. This list of controllers includes the following Atmosphere
Controllers:
• SSi AC20
• Yokogawa 750
• Honeywell UDC3300
• Dualpro 1 Modbus
• Dualpro 2 Modbus
• Dualpro 1 MMI
• Dualpro 2 MMI
• Eurotherm 2404
• Eurotherm 2500
• Carbpro v3.5
• Carbpro v3.0
• CarbPC
• 9200 Loop 1
• IR Base
This list of controllers includes the following Temperature Controllers:
• SSi 7EK
• Yokogawa 750