Super Systems 9200 User Manual
Page 26
Model 9200 Programmable Dual-loop Controller
SSi Manual SERIES 9200
26 Programmable Dual-loop
Highlighting the relay that you wish to assign and pressing the Enter key takes you to a screen that has
the following choices:
•
Loop 1 fwd
•
Loop 1 rev
•
Loop 2 fwd
•
Loop 2 rev
•
Loop 3 fwd
•
Loop 3 rev
•
Programmer alarm
•
Alarm 1
•
Alarm 2
•
Alarm 3
•
Event 0 through Event 15
•
Burn off
•
IN 1 Relay SP A
•
IN 1 Relay SP B
•
IN 1 Relay SP C
•
IN 2 Relay SP A
•
IN 2 Relay SP B
•
IN 2 Relay SP C
•
IN 3 Relay SP A
•
IN 3 Relay SP B
•
IN 3 Relay SP C
From these choices, you can select which function you wish assigned to Relays 1 through 8.
Pressing the Esc key returns you to the Menu Screen.
Relay Set Points
Highlighting the above menu option and
pressing the Enter key, moves the operator to
the screen below.
Highlighting one of the choices below allows the
operator to change the value of the highlighted
selection using the numeric keypad that pops
up.
These values are only valid if the assigned relay
has been assigned IN? Relay SP ? (where?
equals actual value) on the Relay Assignment
Screen.
Pressing the Esc key returns you to the Menu Screen.